Week 12: Prototype and Arduino

Setting up Arduino on the Protoype

Now we have put all the part of the prototype together and I have now set up the Arduino board to the prototype.

This is the front view of the prototype. The rail doe the motors and car is placed at the top of the timber and is covered by balsa wood and texture to tidy up for the clean look of the prototype.

The shelf is made for the Arduino board to be placed as well as other mechanic component for the prototype. The box is attached at the bottom is balance the prototype to stand on its own.

This is when the Arduino board is placed. There are 4 wires from the board attached to the two motors. Two 9 V batteries and a ser are place on the stand. The full rotation servo will be installed on the car.

Arduino will be plug into my laptop for the power source and to upload a code for the board.